Spray Bottle – 24 oz (Content Check Boxes & Graduations) Finish Systems Limited Edition

Specifications:

• 24 oz size (0.70 L)
• Sold individually (each)
• Bottle – HDPE material
• Sprayer – Polypropylene material
• Nitrile O-rings
• Spray bottle is a round shape design
• Spray bottle has a natural color
• 28/400 neck size
• Dimensions: 3.438″ Diameter x 6.873” Height
• 1.4ml per stroke
• Weight: 0.165 lbs.

Information:

If using for a RapidAir FastPipe installation, please see information and steps below:

The spray bottle is for use with the RapidAir FastPipe compressed air system.  The spray bottle (F0139) is used to wet the end of the pipe with a very diluted soapy water solution.  This allows the FastPipe fitting to slip over the pipe end and not disturb the O-ring in the fitting.  

FastPipe Installation Steps:

1. CUT PIPE TO LENGTH with tubbing cutter (cut must be square)

          (DO NOT USE HACK SAW)

1. DEBURR the end of the pipe outside and inside

          (a smooth edge allows easy fitting assembly and no damage to the fitting o-ring)

1. MARK END OF PIPE for the proper insertion depth

• ¾” Fittings: 2 inches
• 1” Fittings: 2 ¾ inches
• 1 ½” Fittings: 4 inches
• 2” Fittings: 4 ¾ inches
• 3” Fittings: 4 ½ inches

1. WET END OF PIPE, with very diluted soapy water

         (DO NOT USE ANY OIL OR GREASE LUBRICANT)

1. LOOSEN fitting cone nut partially

         LOOK INSIDE EACH FITTING FOR INNER PARTS

         (inner parts, o-ring, stainless steel bite ring)

1. INSERT PIPE into fitting until pipe bottoms out

         HAND TIGHTEN fitting

         FULLY TIGHTEN fitting with FastPipe spanner wrenches

Please note that the spray bottle can also be purchased as part of the installation tool kit based on the size of FastPipe that you are installing.  In addition, the Pipe Selection Guide and Quote Form can be found below.