RapidAir FastPipe Saddle Drop Drill Bit (Various Sizes) Best Sale

Specifications:

• RapidAir FastPipe drill bit sizes (drill bit size based on the size of FastPipe you are installing the saddle drop on):  1” Main Pipe (creates a 9/16” hole diameter), 1 ½” – 3” Main Pipe (creates a 3/4” hole diameter)
• Drill bits are sold individually

Installation Steps (see pictures above):

1. Position saddle drop opposite the side of the pipe that needs the hole. Tighten securely and mark the pipe by the raised locating mark on the fitting.  Mark the pipe both horizontally and vertically along the fitting edge.
2. Drill thru one side of pipe with the drill bit, using the hole in the fitting as a locator.
3. Insert the saddle drop gasket into the molded cavity.
4. Position the saddle drop over the drilled hole with aligning marks, tighten securely.
5. Attach the necessary drop pipe or threaded adapter.

Saddle Drop Installation Tips:

• System must be depressurized before installing, wear eye protection
• The drop can be used in any position on the pipe
• Avoid putting the hole at the bottom of the pipe to prevent condensate or debris from entering the drop pipe
• To prevent chips from entering the pipe interior, stop drilling occasionally and blow out chips, grease the end of the drilling tool
• Allen wrench for tightening is 6mm size

*(Please note that the drill bit size (range) needs to match the FastPipe that you are working with to ensure that they will work properly.  In addition, the Pipe Selection Guide and Quote Form can be found below).