3M Accuspray HG “All In One” HVLP Gravity Feed Spray Gun Package – (16580) High Quality

Specifications:

• Air Inlet – 1/4” NPS (m)
• Weight – 11.2 oz.
• Required atomizing air pressure is 20 psi
• Required atomizing air volume is 13 cfm

All In One Spray Gun Package Includes: 

• Atomizing heads included (1.2 mm, 1.3 mm, 1.4 mm & 1.8 mm – 1 of each size)
• Airflow control valve
• Color Identification Clips (10 included – 2 each of 5 colors)
• 650 ml (22 oz.) PPS cup
• Liners & lids (5 included – filtered Lids 1 @ 125 micron (blue) & 4 @ 200 micron (clear))
• Mix ratio card included
• PPS Sealing Plugs (3 included)
• Quick start guide & owner’s manual
• 2.0 mm atomizing heads sold separately

*(Please note that the spray gun does not require a repair kit.  For more detailed information on the spray gun such as parts, setup & maintenance, please contact us).

Note:

3M^TM HG and HGP Care and Cleaning Procedures

Do not backpressure the gun.

There are two Teflon O-rings or seals in the atomizing head. When you slide the atomizing head onto the needle the seals are pushed out towards the front of the gun. This seals the needle passage so the air and fluid going through the gun does not blow back into the gun body. If you back pressure the gun it will flip the Teflon seals so they point back into the gun. When you add fluid and pressure it sneaks past the seals and comes out in front of the handle.

The solution is to clean the gun properly.

While the atomizing head is on the gun, fill it half way with whatever cleaner is required for your coating. Cover and shake it a bit to loosen any residue. Pull the trigger and drain. Fill the atomizing head two more times with cleaner and drain through the tip by pulling the trigger. Pull the atomizing head straight off the gun. Do not twist as you’re pulling. Fill the needle port on the back side of the atomizing head with cleaner and drain. Inspect to make sure there is no residue left in the atomizing head and repeat if needed.